044 — Guide for configuring your Polycom

For your phone to work with the Ubity VoIP system, you must first configure it. To do so, please follow the instructions below.

For Polycom Sound Point

Press the Menu button on the unit.
Select option 3 Settings… then 1 Basic… and finally 5 Restart the phone…
Once your phone has restarted, press Setup.
Enter the password 456 and confirm with OK.
Press the down arrow to select Server menu and confirm by pressing Select.
The Server Type line is selected. Press Edit, then click the right arrow until HTTP(S) appears
(if HTTP(S) is not in the list, select HTTP). Press OK to confirm.
The Server Address line is selected. Press Edit, then enter the address p.ubity.com using your phone keypad. Press OK to confirm.
Press Exit several times.
Choose Save and Reboot.
Your phone should restart, load its configuration and possibly a new version of the firmware. This may take up to ten minutes.

Press the Menu button..
Go to the Settings menu (with a gear icon).
Select option 2 Advanced…
Enter password 456 and press Enter.
Go to option 1 Administration settings… then 1 Network Configuration… and finally Provisionning Server…
Go to Server Type (you might have to press Edit) and select HTTPS.
Go to Server Address (you might have to press Edit) and enter the address p.ubity.com using your phone keypad. Then press OK.
Return to the Settings menu. Select 1 Basic… then 11 Restart the phone and…
Your phone should restart, load its configuration and possibly a new version of the firmware. This may take up to ten minutes.